Charge Controller Circuit

3 ways to control electrical utility costs

Capacitors are energy storage devices that can deliver a lethal shock long after the power to them is disconnected. Most capacitors are equipped with a discharge circuit but, when the circuit fails, a shock hazard still exists for an extended period of time. When testing is required with the voltage applied, you must take extreme care. Capacitor bank maintenance requires training that’s specific to the equipment, its application and the task you’re expected to perform. In addition, the proper personal protective equipment (PPE) in accordance with NFPA 70E is required.

Additional hazards are involved in working with current transformer (CT) circuits, including the wiring and shorting block. The CT itself is normally located in the switchboard, not in the capacitor bank enclosure. Even after the capacitor bank has been de-energized, there’s a danger of electrical shock from the CT wiring. If the CT circuit is opened when there’s a load on the switchboard, the CT can develop a lethal voltage across its terminals.

Source: Plant Services

Notebook Comparison Notebook Battery FAQ

1. Activation: For just purchased the laptop battery, we usually have to activate the battery operation, since the new cells are likely to have very little residual power, need to first give the battery charge. In the off state, charge, charging time is greater than 6 hours; in the boot state charge, charging time is greater than 8 hours. This process should not disconnect the external power supply, please use the previous three all used up battery to charge again, and the charging time can not charge less than the first time, to ensure maximum battery is activated to ensure the effective battery lifetime. 2. Storage: If the battery can be removed without a long time, but must ensure that 40% of battery power, because the battery will be placed about 1% per day of electricity loss, that the purpose is to prevent battery over-discharge result in damage Battery power is also out of the factory with the remaining consideration in this regard. In addition, every month or so to conduct a full battery charge and discharge, to ensure no loss of activity of lithium ion. Some models have a battery pad, play a role in supporting notebook, remove the battery will cause the machine imbalance, on this point there is no good solution. However, users can, through their own DIY mats to achieve the same functionality. 3. Use of the environment: Try not to use the laptop battery under high temperature conditions, in the case of high temperatures shorten the life span laptop battery would be more serious, and even there will be a risk of explosion, we try to avoid extremely high or low temperature environments , not only to extend laptop battery life, on the laptop battery has no small help. 4. Special situation: Basically, laptop battery explosion probability is not high, so we did not need to worry about notebooks have more explosions, but we in the course of normal use, we should note that, if the notebook batteries overheating or expansion and deformation, should immediately stop using removed, because laptop battery in normal use, will not have too high a temperature, basically the feeling of warm, relatively speaking, if the heat higher, indicating accumulation of heat inside the batteries situation, thus more dangerous. Notebook batteries for notebook battery usually within the values of the control circuit, when the control circuit of the recorded data with the state of the battery's own power deviation, the battery may have been unable to control the circuit record of elegance, which is in fact the battery has been full, this problem can usually be resolved by way of correction, if not to correct for normal use there is no effect, charging protection circuit can not be filled in automatically after a long break, to avoid overcharging the battery in as the host damage.

...

Read more...

News

Read all 'USB 3.0' posts in Crave

CNET - May 05, 2010

A host controller allows computer devices to communicate with the operating system and is a crucial component for implementing USB 3.0 on computer systems.

Power Controller protects critical military equipment.

ThomasNet Industrial News Room - Apr 30, 2010

Products include 12V/24V MPPT charge controller, 12V/24V more ISO 9001:2000 & AS 9100:2004 certified manufacturer & designer equipment & devices for

Convergence in Telecom

Voice & Data Online - May 19, 2010

BRAS acts as service controller for all data traffic. Service control for voice traffic is carried out in Soft Switch. Service control function for VOIP

Design challenges for solar-powered HB-LED lighting

EDN.com - May 13, 2010

You can buy these controllers off the shelf, or designed for your application—often by combining the MPPT and charge-controller circuits.

MacFixIt Answers

CNET (blog) - May 07, 2010

Try a different outlet or different circuit in your home. Sometimes an overloaded or noisy circuit (can happen from improper grounding or multiple